Skip to content
Open in AI

KH-UCANFDG2X4-Mini ​

Four-channel USB CAN FD bare-board module

Four CAN FD channels for board-level integration

USB 2.0 High-Speed connects the host. Each CAN FD channel has a dedicated GH1.25 connector.

The KH-UCANFDG2X4-Mini adds four CAN / CAN FD interfaces over USB 2.0 High-Speed. The module draws power from USB and has four through-holes for mounting inside equipment.

It replaces the discontinued KH-UCANFDX4-Mini. Before replacing an existing module, confirm the wiring and installation requirements with Kunhong Technical Support.

Product Features ​

  • Supports CAN 2.0A/B, ISO CAN FD and Non-ISO CAN FD, with CAN FD data rates up to 12 Mbit/s.
  • Provides 3000 V electrical isolation on the CAN side and an independent multicolor status LED for each channel.
  • Supports CANmeleon firmware switching. Choose the firmware and driver that match your diagnostic tool.

Applications ​

Multi-axis robots, industrial control equipment and automotive component test benches can use the module to connect to multiple CAN / CAN FD buses.

General ​

ParameterSpecification
Product modelKH-UCANFDG2X4-MINI
Product seriesKH-UCANFD-MINI
EnclosureNone. Bare-board module.
Board dimensionsSee the 2D dimension drawing.
Mounting holes4 × Ø2 mm through-holes
Host interfaceUSB 2.0 High-Speed, USB-A on the supplied cable
On-board USB connectorGH1.25, 5 pins
USB link speedUp to 480 Mbit/s
Power supplyUSB bus powered, 5 V DC

CAN Communication ​

ParameterSpecification
CAN channels4 (CAN1 through CAN4)
CAN connectorsOne 3-pin GH1.25 connector per channel
Bus protocolsCAN 2.0A, CAN 2.0B, ISO CAN FD and Non-ISO CAN FD
Arbitration rate25–1000 kbit/s
CAN FD data rate25–12000 kbit/s
TerminationOn-board, 120 Ω nominal
Latency18 μs minimum, 40 μs typical
Hardware timestampsSupported, with 1 μs resolution
Channel LEDsIndependent multicolor status LED for each channel
User buttonNone
Digital I/ONone

Environment and Protection ​

ParameterSpecification
Isolation typeElectrical isolation
Isolation voltage3000 V
ESD protection±8 kV contact discharge, ±15 kV air discharge
Operating temperature−40 to +85 °C
Storage temperature−40 to +85 °C
Operating humidity10% to 90%, non-condensing
EnvironmentKeep away from strong acids, strong bases and strong electromagnetic fields
Water protectionNone

CAN pinout (V0.1.0) ​

In the orientation shown below, the four GH1.25 connectors on the right are labeled CAN4, CAN3, CAN2, and CAN1 from top to bottom.

PinSignal
1GND
2CAN_L
3CAN_H

USB host interface ​

The on-board USB connector is at the bottom left of the V0.1.0 diagram. Use the supplied USB-A to 5-pin GH1.25 cable and check its orientation against the markings on your board revision.

KH-UCANFDG2X4-Mini V0.1.0 connector diagram showing the USB location and pin assignments for CAN1 through CAN4

2D Dimension Drawing ​

KH-UCANFDG2X4-Mini 2D dimension drawing showing board outline, height and mounting holes